Some General Answer: Assuming reasonably free flowing material under 6% moisture (which by the way is considered dry)

Your information and my response below:

MATERIAL TO BE HANDLED :- CRUSHED AGGREGATE
I will make assumption .....100 lbs/cu/ft typical limestone

2)CAPACITY :- 70TPH
I will assume (STPH) Imperial Tons

3)FEEDING EQUIPMENT :- BELT COPNVEYOR
Conveyor should be miniumum 36" wide, but ensure a full spread to full width of the screen to ensure we get the tonnage out

4)TYPE OF SCREEN: See below pick

5)MATERIAL TO BE SCREEN :- BELOW 6MM
Assume install 6mm square opening,T304 stainless steel, middling wire diameter range (Could go FLEXMAT) if needed - a superior choice especially if crushed material
OVER SIZE :- (-)75 TO (-)6MM

6) QTY :-4 NOS ???

CAN SOMEONE SUGGEST THE FOLLOWING:-

1)TYPE OF SCREEN IE ROTARY / VIBRATING
Circle throw, vibratings screen at 25 degree decline,
1/4 (6mm) circle 1000-1100 rpm range, running counterflow
rotation

2) SIZE OF SCREEN: 5x16 (90 sq ft screening area) Assuming we can pass between .8 to 1.0 tons per sq foot by sizing and without the benefit of a full sieve analysis of the feed

3) MOTOR HP ETC. 7.5 Hp

4) MANUFACTURER NAME: Dillon screen 2 brg circle throw inclined

NOTE: Could be smaller depending on sieve analysis....if we do anything here.....SMALLER stroke and faster RPM and steeper angle are all do-able by the rules.

Many makes of screens can do this stone quite nicely.